Timb-R-Lock Instructions

WARNING:
A. Do not step on stand unless T-Bar screw and strapping are both secure.
B. T-Bar screw is an added safety device.
C. Always check belts for damage.
D. Always use your fall-restraint system whenever you are off the ground.
 
(Includes: Tree Stand; T-Bar Screw; Stabilizer Strap)

1. Stand may be "Backpacked" up the tree or pulled with a rope into position.

2. Plan your climb-position yourself so you will be right of where you want stand placed.

3. With stand at desired height, install T-Bar and hang folded stand on T-Bar against tree. Pull ratchet and strap around tree and place hook through 1" x 2" flat metal. Pull loose end of strap until slack is removed then ratchet tight. Unfold stand.

4. Once stand is unfolded pull stabilizer strap on bottom of stand around tree and hook onto the upright seat bar, then pull loose end of strap until tight.

(Never use stand without the T-Bar and straps being installed properly).

5. To remove: Step off stand and position yourself safely beside stand. Release ratchet strap and stabilizer strap then lift stand off T-Bar screw then lower to the ground.

When inserting tree steps to climb tree always use your fall-restraint system and keep the end around the tree above your head as show in Fig (1).	Once at the height in which you want to hunt, be sure your fall-restraint system is above where you want stand placed, as shown in Figure (2).
Screw the T-Bar into the tree until the handle is approximately 1" from the tree as shown in Fig (3).	Once the T-Bar is inserted, pull the stand up with a rope and place cross bar between the T-Bar and tree. T-Bar should be in vertical position as shown in Fig (4). For 301-C and 301-R. T-Bar should be horizontal for 301-AS.